MBE 4000 SERVICE MANUAL 3. Install the heat exchanger housing on the cylinder block. Install the housing bolts and tighten them in the order shown in see Figure 3-22. Tighten each bolt 60 N·m (44 lb·ft). Figure 3-22 Tightening Pattern, Heat Exchanger Housing Bolts [a] Clean the mating surfaces of the heat exchanger housing and the cylinder block. Remove any bits of adhering gasket material. [b] Replace the heat exchanger housing gasket. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 3-29