Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

3.7 OIL HEAT EXCHANGER AND FILTER HOUSING 4. Install a new filter element and O-ring in the oil filter housing. See Figure 3-23. 1. Oil Filter Cap 3. Oil Filter Element 2. O-ring Figure 3-23 Oil Filter Assembly 5. Install the oil filter cap. Tighten the cap nut 25 N·m (18 lb·ft). 6. Install the oil pressure/temperature sensor on the heat exchanger/filter housing. 7. Connect the wiring harness to the oil pressure/temperature sensor. 8. Install the turbocharger on the engine. Refer to section 6.3.3. 9. Connect the coolant pump shunt line to the coolant pump inlet pipe. 10. Fill the cooling system. Refer to section 4.1.1. All information subject to change without notice.

3-30 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION