Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

4.2 COOLANT PUMP 8. Remove the inlet pipe from the coolant pump housing. See Figure 4-4. 1. Lower Coolant Tube 5. Coolant Pump Housing 2. Inlet Pipe Mounting Bolt 6. Front Idler and Tensioner Support 3. Inlet Pipe 7. Coolant Pump Support Mounting Bolt 4. Inlet Pipe Gasket 8. Upper Coolant Tube Figure 4-4 Coolant Pump Inlet Pipe (exploded view) NOTE: Catch any coolant that runs out of the inlet pipe or coolant pump in a suitable container. 9. Remove the upper coolant tube from the thermostat housing. 10. Remove the coolant pump from the cylinder block. Discard the gasket. 11.

On both the coolant pump and the cylinder block, clean the sealing surfaces (where the gasket was attached) of any adhering bits of gasket material. All information subject to change without notice. 4-10 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION