MBE 4000 SERVICE MANUAL 4. Using an appropriate drift, press the drive shaft and bearing assembly out of the impeller and through the coolant pump housing. This frees the impeller from the housing. See Figure 4-7. 1. Sleeve Seal 4. Receptacle 2. Drift 5. Drive Shaft and Bearing Assembly 3. Impeller Figure 4-7 Removing the Drive Shaft 5. Remove the sleeve seal from the coolant pump housing. 4.2.2.1 Coolant Pump Inspection Inspect the coolant pump unit as follows: 1. Check all coolant pump components for signs of damage. Replace any damaged components. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 4-13