4.2 COOLANT PUMP 2. Measure the following wear dimensions. Replace any component that is not within tolerance as Listed in Table 4-3. Table 4-3 Coolant Pump Assembly Wear Dimensions 4.2.3 Coolant Pump Assembly Assemble the coolant pump unit as follows: 1. Press the drive shaft and bearing assembly into the coolant pump housing. See Figure 4-8. 1. Drive Shaft 2. Coolant Pump Housing Figure 4-8 Installing the Drive Shaft All information subject to change without notice.
4-14 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Wear Dimensions, mm (inch) Drive Shaft Diameter (at the hub) 25.048-25.061 (0.9861-0.9867) Hub Inside Diameter 24.995-25.008 (0.9841-0.9846) Bearing Outside Diameter 54.981-54.994 (2.1646-2.1651) Bearing Housing Diameter 54.930-54.960 (2.1626-2.1638) Drive Shaft Diameter (at the impeller) 15.045-15.056 (0.5923-0.5928) Impeller Inside Diameter 15.000-15.018 (0.5906-0.5913) Impeller Outside Diameter 124-125 (4.88-4.92) Impeller - Maximum Out-Of-Round 0.15 (0.0059)