Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 4.5 THERMOSTAT Perform the following procedures for removal and installation of the thermostat. 4.5.1 Thermostat Removal Remove the thermostat as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain the coolant from the engine. Refer to section 4.1.1. 2. Remove the upper coolant tube from the thermostat housing. See Figure 4-14. 1. Mounting Bolt 4. O-ring 2. Thermostat Housing 5. Thermostat 3. Upper Coolant Tube 6.

Coolant Pump Housing Figure 4-14 Thermostat Removal or Installation All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 4-25