4.5 THERMOSTAT 3. Remove the mounting screws attaching the thermostat housing to the coolant pump housing. Remove the thermostat housing. NOTE: Catch any coolant that runs out of the upper coolant tube or coolant pump housing. 4. Remove the thermostats and O-rings from the coolant pump housing. Discard the O-rings. 5. Check both thermostats for proper operation. For detailed procedures, refer to section 4.5.2.1. Replace any thermostat that fails one or more tests. 4.5.2 Thermostat Installation Install the thermostat as follows: 1. Install a new O-ring on each thermostat. 2. Install the original and/or replacement thermostats. 3. Install the thermostat housing.
Install the mounting bolts attaching the thermostat housing to the coolant pump housing. Tighten each mounting bolt 25 N·m (18 lb·ft). See Figure 4-14. 4. Install the upper coolant tube on the thermostat housing. Tighten the hose clamp until firm. 5. Fill the engine with coolant, and check for leaks and proper operation. Refer to section 4.1.1. 4.5.2.1 Thermostat Checking Check the thermostat as follows: 1. Remove the thermostat from the coolant pump. Refer to section 4.5.1. All information subject to change without notice. 4-26 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION