4.7 COOLANT TEMPERATURE SENSOR 4.7 COOLANT TEMPERATURE SENSOR Perform the following procedures for removal and installation of the coolant temperature sensor. 4.7.1 Coolant Temperature Sensor Disassembly Disassemble the coolant temperature sensor as follows: HOT COOLANT To avoid scalding from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Wear adequate protective clothing (face shield, rubber gloves, apron, and boots). Remove the cap slowly to relieve pressure. 1. Drain some coolant from the engine. NOTE: It is not necessary to drain all the coolant from the engine to do this procedure.
Enough has to be drained to prevent coolant from leaking out while the sensor is being changed. 2. Remove the engine trim panel. All information subject to change without notice. 4-32 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION