6.3 TURBOCHARGER 8. Remove the oil supply line from the turbocharger and the cylinder block. See Figure 6-11. 1. Seal Ring 3. Oil Supply Line 2. Banjo Fitting 4. Banjo Bolt Figure 6-11 Oil Supply Line Fasteners [a] Remove the two bolts attaching the oil supply line to the turbocharger. Discard the gasket. [b] Remove the banjo bolt attaching the oil supply line to the cylinder block. Discard the two seal rings. 9. Remove the nuts that attach the turbocharger to the exhaust manifold. Remove the turbocharger and exhaust brake valve housing. 10. Remove the exhaust brake valve housing from the turbocharger (if needed). 6.3.3 Turbocharger Installation Install the turbocharger as follows: 1.
Inspect the turbo inlet hose, turbocharger outlet pipe, and the oil supply and return lines for restrictions or foreign objects. 2. Using new nuts, install the exhaust brake valve housing on the turbocharger (if removed). Tighten the nuts 50 N·m (37 lb·ft). All information subject to change without notice. 6-14 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION