Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 3. Install the turbocharger on the exhaust manifold. listed in Table 6-1 are the torque values. Table 6-1 Turbocharger Torque Values [a] Coat four new prevailing torque locknuts with a light coating of high temperature grease. [b] Make sure that the mating surfaces of the turbocharger and the exhaust manifold are clean and free of damage. [c] Position the turbocharger over the mounting studs on the exhaust manifold. [d] Install the nuts and tighten them 50 N·m (37 lb·ft). 4. Attach the oil return line to the turbocharger and the cylinder block. Listed in Table 6-1 are the torque values.

[a] Install a new gasket where the end flange of the return line meets the turbocharger. [b] Install the mounting bolts through the holes in the end flange. Tighten them 25 N·m (18 lb·ft). [c] Install two new seal rings on the banjo fitting at the other end of the return line. [d] Install the banjo bolt attaching the return line to the engine oil return inlet. Tighten the bolt 35 N·m (26 lb·ft). 5. Fill the bearing housing with clean engine oil through the oil inlet port. Turn the turbocharger wheel several times to coat the bearings with oil. NOTE:

If the turbocharger wheel cannot be spun freely by hand or if there is any indication of rubbing or scraping, determine the reason before starting the engine. One cause of wheel rubbing is a misaligned turbocharger housing. 6. Refill the oil inlet port and connect the oil supply line. listed in Table 6-1 are the torque values. [a] Install a new gasket where the end flange of the supply line meets the turbocharger. All information subject to change without notice.

6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 6-15 Description N·m (lb·ft) Exhaust Brake Valve Housing to Turbocharger 50 (37) Heat Shield Mounting Bolts 25 (18) Turbocharger to Exhaust Manifold 50 (37) Turbocharger Oil Return Line Mounting Bolts 25 (18) Turbocharger Oil Line Banjo Bolts 35 (26) Turbocharger Oil Supply Line Mounting Bolts 25 (18) Turbocharger Oil Return Line Connection 50 (37) Turbocharger Oil Return Line Banjo Bolt 120 (88)