Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

6.3 TURBOCHARGER [b] Install the mounting bolts through the holes in the end flange and the heat shield bracket. Tighten them 25 N·m (18 lb·ft). [c] Install two new seal rings on the banjo fitting at the other end of the supply line. [d] Install the banjo bolt attaching the supply line to the cylinder block. Tighten the bolt 35 N·m (26 lb·ft). 7. Attach the air intake elbow to the turbocharger. Tighten the clamp 10 N·m (7 lb·ft). 8. Attach the turbocharger outlet pipe to the turbocharger. Tighten the clamp 6 N·cm (4 lb·ft). 9. Connect the exhaust pipe to the exhaust brake valve housing. 10. Install the air line on the exhaust brake cylinder, as removed. 11. Install the air cleaner.

PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 12. Start the engine and allow it to run at idle speed for three to four minutes before accelerating. 13. Check for oil leaks. Correct any if found. 14. Lower the hood and remove the chocks from the rear tires. All information subject to change without notice.

6-16 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION