Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL NOTICE: There is a front and rear exhaust manifold gasket and the rear gasket is marked with a deep notch on top. The front gasket must be installed before the rear gasket can be installed. NOTE: At this point, the heat exchanger and heat exchanger mounting bracket should be installed on the block, but the remaining exhaust manifold installation graphics will not show these two parts installed. NOTE: The exhaust manifold gasket studs are to be removed after installing the EGR cooler support bracket. 2. Install stud with M8 nut with collar onto exhaust manifold center piece. Do not tighten nut at this point. NOTE:

Stud must be installed on exhaust manifold center piece before fitting the two end pieces of manifold into center piece. 1. Stud 3. Exhaust Manifold Center Piece 2. M8 Nut with Collar Figure 7-15 Installing Stud in Exhaust Manifold Center Piece All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 7-23