7.4 EGR COOLER AND COOLER SUPPORT BRACKET 7.4 EGR COOLER AND COOLER SUPPORT BRACKET The EGR system is equipped with a single-pass cooler. Exhaust gasses coming from the first three cylinders are directed through the EGR shut off valve, through the cooler and reed valves, past the EGR control valve and the mixer, then back to the cylinder. 7.4.1 EGR Cooler and Support Bracket Removal Remove the EGR cooler and its support bracket as follows: NOTE: The exhaust manifold and the gas inlet pipe have already been removed at this point. It is then possible to remove the cooler and support bracket without removing the throttle valve first. 1.
Disconnect the coolant vent line located on top of the EGR cooler. See Figure 7-18. 1. Coolant Outlet Pipe Bolts 4. EGR Coolant Outlet Pipe 2. Coolant Vent Line 5. Coolant Outlet Pipe Bracket 3. Membrane Figure 7-18 Removal of Coolant Vent Line and Coolant Outlet Pipe 2. Remove the bolt attaching the coolant outlet pipe bracket to the pipe. Remove the bracket. 3. Remove the two bolts attaching the coolant outlet pipe flange to the coolant pump. Discard the gasket. All information subject to change without notice. 7-26 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION