MBE 4000 SERVICE MANUAL 4. Pull the coolant outlet pipe away from the cooler, leaving the connecting membrane in the EGR cooler boss. 5. Remove the EGR temperature sensor from the reed valve housing and disconnect the sensor wiring harness where it is attached with cable ties to the reed valve housing mounting bracket. See Figure 7-19. 1. EGR Air Temperature Sensor 2. Reed Valve Housing Bracket Figure 7-19 Removing EGR Air Temp. Sensor 6. Remove the three bolts from the front bracket that holds and stabilizes the reed valve housing to the thermostat housing. See Figure 7-19. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 7-27