MBE 4000 SERVICE MANUAL 13. With the cooler completely loosened at this point, pull the cooler housing flange away from the EGR control valve. As the cooler is lifted, slide the cooler inlet pipe up through the opening in the cooler support bracket. See Figure 7-23. 1. Cylinder Heads 4. EGR Cooler 2. EGR CoolerTightening Clamps 5. EGR Cooler Support 3. Tightening Tool for Clamps Figure 7-23 Removing EGR Cooler NOTE: Before removing the eight bolts from the EGR cooler support, insert the four guide studs into the exhaust manifold gasket holes to support the gaskets once the cooler support is removed. All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 7-31