Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

8.1 DRIVE BELTS 4. Remove the belt tensioner and tensioner pulley from the mounting pad on the cylinder block. 8.1.8 Belt Tensioner Installation Install the belt tensioner as follows: 1. Align the guide pins on the belt tensioner with the holes in the mounting pad. 2. Position the belt tensioner to the mounting pad and secure in place with the mounting bolt. Tighten the bolt 50 N·m (37 lb·ft). 3. Release the belt tensioner to allow the belt to be installed. Refer to section 8.1.1. 4. Install the drive belt on the pulleys, as removed. 5. Restore the tension on the drive belt. 8.1.9 Idler Pulley Removal Remove the idler pulley as follows: NOTE: This procedure works for all idler pulleys.

To identify the correct pulley, see Figure 8-9. 1. Mounting Bolt 4. Fan Idler Pulley #2 2. Main Drive Belt Idler Pulley 5. Fan Idler Pulley #1 3. Coolant Pump Inlet Pipe Figure 8-9 Idler Pulleys All information subject to change without notice. 8-12 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION