MBE 4000 SERVICE MANUAL 7. Remove the four mounting bolts attaching the air compressor to the crankcase. See Figure 10-4. 1. Inboard Upper Mounting Bolt 5. Outboard Upper Mounting Bolt 2. Air Compressor 6. Outboard Lower Mounting Bolt 3. Cylinder Block 7. Inboard Lower Mounting Bolt 4. Flywheel Housing Figure 10-4 Air Compressor Mounting NOTE: The mounting bolts are of different lengths. The outboard upper mounting bolt is removed from the rear. 8. Slide the drive gear away from the flywheel. Catch any oil that runs out and dispose of it properly. 10.1.1.1 Air Compressor Inspection Inspect the air compressor as follows: 1.
Inspect the O-rings on the fittings at the air system ports and replace if necessary. If the O-rings are damaged, replace the fittings also. 2. Replace the O-ring between the power steering pump and the air compressor. 3. Install the locking device (J 46177 or 457 589 03 63 00) on the driveshaft end of the air compressor. This locks the driveshaft to allow removal of the drive nut. 4. Remove the drive gear from the air compressor. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 10-7