10.1 AIR COMPRESSOR [a] Place the air compressor and locking device (J 46177 or 457 589 03 63 00) in a vise. Make sure the locking device is tightly secured and cannot slip or slide out of the vise. [b] Using an impact wrench, remove the drive nut from the drive gear. [c] Remove the locking device (J 46177 or 457 589 03 63 00) from the air compressor and the vise. [d] Remove the drive gear from the air compressor with a gear puller, if necessary. [e] Discard the O-ring on the driveshaft end of the air compressor. 5. Inspect the drive gear for worn or broken teeth, spalling, and corrosion. Replace the drive gear if necessary. 6.
Install the drive gear, drive nut, and a new O-ring on the driveshaft end of the air compressor. Tighten the drive nut 290 N·m (214 lb·ft). See Figure 10-5. 1. Air Compressor 3. Drive Gear 2. O-ring 4. Drive Nut Figure 10-5 Air Compressor Drive Gear Installation 7. Release the air compressor from the vise. 10.1.2 Air Compressor Installation Install the air compressor as follows: 1. Install the air compressor. All information subject to change without notice. 10-8 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION