MBE 4000 SERVICE MANUAL 12.1 VALVE LASH CHECKING Check and adjust the valve lash as follows: NOTE: Adjust the valve lash when the engine is cold. Wait at least 30 minutes after shutdown, even if the engine ran only a short time. Select a method for adjusting the valves. There are two acceptable methods for adjusting the valves, prior to checking the valve lash: In order, according to the timing sequence used for fuel injection (see Method One—Adjust Each Cylinder in Firing Order); By type of valve, depending on crankshaft position (see Method Two—Adjust All Valves Using Two Crankshaft Positions).See Figure 12-1 for the cylinder and valve layout on MBE 4000 engines.
Figure 12-1 Cylinder and Valve Layout All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 12-3