12.1 VALVE LASH CHECKING 12.1.1 Method One — Adjust Each Cylinder in Firing Order Method one allows you to adjust each cylinder in the order in which fuel is injected. The crankshaft must be repositioned after each cylinder is adjusted as listed in Table 12-1. Table 12-1 Valve Adjustment (Method One) NOTE: Clean each cylinder head cover before removing it. 1. Remove the cylinder head covers. See Figure 12-2. Refer to section 1.1.1. 1. Socket-Head Bolt 3. Gasket 2. Cylinder Head Cover 4. Cylinder Head Figure 12-2 Cylinder Head Cover, (exploded view) 2. Remove the inspection cover on theflywheel housing. All information subject to change without notice.
12-4 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Engine Crankshaft Position Cylinders Cylinders Cylinders Cylinders Cylinders Cylinders MBE 4000 Ignition TDC 1 5 3 6 2 4 MBE 4000 Valve Overlap 6 2 4 1 5 3