MBE 4000 SERVICE MANUAL PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 2. Run the engine at moderate speed until the thermostat starts to open, at an operating temperature of approximately 176 C). Then run it for about five minutes longer. Shut down the engine and allow it to cool to approximately 112 F (80 F (50 C). 3. Drain all the cleaning solution. 4.
Flush the cleaning solution from the cooling system. [a] Immediately after draining the cleaning solution, flush the system with clean water. [b] Once the clean water has drained, fill the system again with clean water. [c] Run the engine. Allow the engine to warm up to approximately 176 C), and then run it about five minutes longer. F (80 [d] Drain the hot water. 5. Fill the cooling system with new coolant. For detailed procedures, see the vehicle/chassis maintenance manual. For types of coolant, 14.1.4 Storage Required protective measures for the MBE 4000 engine depend on the following:
The length of time that the engine will be out of service The climate and conditions where the engine is stored After cleaning, engines should, whenever possible, be placed in a dry, well-ventilated place. In all cases, protect the engine against direct exposure to moisture (rain/splash water). If the engine is to be out of service for 12 months or less, anticorrosion measures are not necessary, provided that the place of storage are dry and well-ventilated as described above. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 14-5