1.2 CYLINDER HEAD NOTICE: Do not place the head mating surface down on a flat surface. This would damage the injector nozzles, which protrude slightly. 15. Remove the cylinder head and set it on wooden blocks or on its side. 16. Remove the head gasket. 17. Thoroughly clean the cylinder head, both contact surfaces (head and block), and surfaces inside the cylinder of excess oil, grime, and paint chips. 18. With a straightedge, check the cylinder head surface for warpage. Refer to section 1.2.2.1. Listed in Table 1-1 are warpage limits. Table 1-1 Head Warpage Limits 19. Check the cylinder liner protrusion from the cylinder block. Listed in Table 1-2are the specifications.
Refer to section 1.3.2.2. Table 1-2 Specifications for Measuring Cylinder Liner Protrusion 20. Inspect the cylinder head for cracks or signs of damage. Replace if necessary. 1.2.2 Cylinder Head Installation Install the cylinder head as follows: 1. Install a new head gasket. Match up the holes in gasket with those in the cylinder block and place the head gasket over the guide pins in the block. 2. Position the cylinder head on the head gasket. Make sure the head is seated onto the guide pins. All information subject to change without notice. 1-10 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Limit Over a length of 150 mm (6 in.) 0.015 mm (0.0006 in.) Description Value:
mm (in.) Cylinder Liner Protrusion from block 0.230-0.330 mm (0.0090-0.0130 in.) Difference between the four measuring points Max.: 0.02 mm (0.0007 in.)