1.2 CYLINDER HEAD 22. Install the engine trim cover. NOTE: Prime the fuel system. Refer to section 2.9.2. PERSONAL INJURY Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 23. Turn on the ignition switch and test the engine. Observe the oil pressure gauge to verify the correct oil pressure. The maximum oil pressure readings at idle speed are listed in Table 1-5.
Pay attention to the coolant temperature gauge, warning lights, fluid leaks, and any other signs of a problem. Table 1-5 Oil Pressure Readings 24. Stop the engine, check the coolant level, and top off if necessary. 1.2.2.1 Cylinder Head Inspection and Machining Inspection 1. Remove the cylinder head. Refer to section 1.2.1. 2. Remove the nozzle holder. Refer to section 2.4.1. 3. Remove the intake and exhaust valves. Refer to section 1.19.5. 4. Remove the constant-throttle valve. Refer to section 1.6.1. All information subject to change without notice.
1-14 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Minimum Oil Pressure Reading Engine at Idle Speed 50 kPa (7 psi) Engine at Max. rpm 250 kPa (36 psi)