MBE 4000 SERVICE MANUAL 5. Inspect the contact surface (bottom face) of the cylinder head for warpage, both lengthwise and diagonally. See Figure 1-8. If the gap is larger than 0.015 mm (0.0006 inch), machine the cylinder head. 1. Contact Surface 2. Straightedge Figure 1-8 Measuring Cylinder Head Warpage [a] Place a straightedge lengthwise across the cylinder head contact surface (bottom face). [b] If there is a gap between the lower edge of the straightedge and the contact surface of the cylinder head that is large enough to let light through, insert a feeler gauge into the gap. [c] Measure the amount of warpage with the feeler gauge and compare it to the value listed in Table 1-6.
If the gap is larger than 0.015 mm (0.0006 in.), machine the cylinder head. Table 1-6 Cylinder Head Specifications All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-15 What To Measure How To Measure mm (inch) Maximum Permissible Warpage of Head Mating Surface Lengthwise and Diagonally 0.015 (0.0006) Maximum Permissible Parallelism Deviation of Head Mating Surface At Each of the Four Corners 0.1 (0.004) Overall Height of Cylinder Head When New 113.85-114.15 (4.482-4.494) After Machining 113.5 (4.46)