1.2 CYLINDER HEAD 8. Attach the compression tester (J 6692–B or 000 589 17 21 00) to the test adaptor (J 45392 or 904 589 01 21 00). Snap the fitting at the end of the tester onto the top of the test adaptor. See Figure 1-13. 1. Fitting 4. Constant Throttle Valve Cover 2. Bolt 3. Hold-Down Figure 1-13 Testing Compression Pressure Testing 1. Remove the electrical connectors from all unit pumps. When this is done, the engine will not start. 2. For each cylinder, use the starter to crank the engine at least 8 engine revolutions. The results will be recorded on the gauge of the tester. 3. Compare measurements on the chart with the values listed in Table 1-7.
If the pressure measured is below the minimum compression pressure or above the permissible difference, determine the cause and correct the problem. To remove the cylinder head, Refer to section 1.2.1. Table 1-7 Compression Testing All information subject to change without notice. 1-22 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Pressure in kPa (psi) Minimum Compression Pressure Valve 2800 (406) Permissible Difference Between Individual Cylinders 400 (58)