Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.3 CYLINDER BLOCK 8. Check the condition of the liner collar seat. Make sure that the depth of the collar seat is within the specifications given, listed in Table 1-8. Table 1-8 Cylinder Liner Installation Tolerances 9. Check the deformation of the cylinder liner collar at the contact surface with the seat insert. Make sure that the deformation of the collar does not exceed the admissible maximum given, listed in Table 1-8. Discard the liner if the collar is not within tolerance. NOTE: Do not attempt to machine the liner collar in order to correct inadmissible deformation. Instead, replace the cylinder liner. 10.

Check the deformation of the liner collar seat at the contact surface with the seat insert. Make sure that the deformation of the collar seat does not exceed the admissible maximum given, listed in Table 1-9. Table 1-9 Cylinder Liner Inspection Tolerances 1.3.2 Cylinder Liner Installation Install the cylinder liner as follows: 1. Install new O-rings, clean and dry, in the cylinder block. 2. Install a new seat insert, clean and dry, into the liner collar seat. See Figure 1-16. Check the thickness of the seat insert according to the specifications, listed in Table 1-9. NOTE: The cylinder liner collar and collar seat must remain completely free of oil.

All information subject to change without notice. 1-28 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Value: mm (in.) Cylinder Liner Protrusion, From Block, 1-16, Ref. A. 0.230–0.330 (0.0090–0.0130) Height of the Cylinder Liner Collar, 1-16, Ref. B. 10.10–10.12 (0.3976–0.3984) Depth of the Collar Seat, 1-16, Ref. C. 9.950–10.010 (0.392–0.3941) Thickness of the Seat Insert 0.14–0.16 (0.0055–0.0063) Description Value: mm (in.) Admissible Out-of-Round of the Cylinder Liner, where it contacts the O-rings Max.: 0.02 (0.0007) Admissible Deformation of the Cylinder Liner Collar, at the Contact Surface with the Seat Insert Max.:

0.02 (0.0007) Admissible Deformation of the Liner Collar Seat, at the Contact Surface with the Seat Insert Max.: 0.03 (0.0011)