MBE 4000 SERVICE MANUAL 3. Apply a light coating of engine oil to the lower part of the liner, from where it contacts the O-rings up to the bevelled area. 4. When installing a new liner, make sure that the diameter tolerance code corresponds to the one marked on the piston. See Figure 1-18 for the location of tolerance codes. 1. Piston 2. Cylinder Liner Figure 1-18 Tolerance Codes [a] Cylinder liners with tolerance code A require a piston of code BA. [b] Cylinder liners with tolerance code B require a piston of either code BA or BC. [c] Cylinder liners with tolerance code C require a piston of code BC. All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-29