1.3 CYLINDER BLOCK 5. Install the cylinder liner, using the cylinder liner installation tool (J 46168 or 449 589 01 33 00). See Figure 1-19. 1. Installation Nut 3. Cylinder Block 2. Cylinder Liner Figure 1-19 Cylinder Liner Installation [a] If installing a new liner, be sure to make a reference mark on the liner to match up with the one made on the cylinder block upon removal. NOTICE: Do not overtighten the installation tool. This may deform the liner and make the installation tool more difficult to remove. [b] Tighten the installation tool just enough to hold the installation tool inside the liner without turning. NOTICE:
To prevent damage to the O-rings, the liner must be rotated during installation. NOTE: If installing a new liner, use the first reference mark. If installing the old liner, use the second reference mark, offset 90 degrees from the first one. All information subject to change without notice. 1-30 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION