MBE 4000 SERVICE MANUAL [c] Insert the cylinder liner into the cylinder block until it contacts the O-rings. Continue to insert the liner past the O-rings, being careful to keep turning the installation tool until the liner is properly seated. [d] Remove the installation tool from the cylinder liner. 6. Measure the cylinder liner protrusion from the block. See Figure 1-16. The specifications are listed in Table 1-8. Refer to section 1.3.2.2. 7. Measure the inside diameter of the cylinder liner and check for out-of-round. See Figure 1-20. 1. Cylinder Liner 3. Dial Gauge 2. Quick Calipers 4.
Cylinder Block Figure 1-20 Measuring the Cylinder Liner Inside Diameter [a] Measure at three different locations 60 degrees apart in the area of the two O-rings. [b] Compare the three measurements. If they differ by more than the maximum admissible out-of-round listed in Table 1-9, remove the liner and inspect the two O-rings and their seating area in the cylinder block. [c] If the O-rings are damaged, replace them. [d] Check the out-of-round again until it meets specifications. 8. Install the piston. Refer to section 1.17.2. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-31