Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.3 CYLINDER BLOCK 1.3.2.1 Cylinder Liner Bore Inspection and Measurement Inspection Inspect the cylinder liner bore as follows: 1. Check the wall of the cylinder liner for signs of excessive wear or deformation. 2. Check the honing pattern on the cylinder liner for damage caused by penetration of dirt into the cylinder. If the honing pattern is faded or no longer visible, discard the cylinder liner. See Figure 1-21 for an intact honing pattern and see Figure 1-22 for a faded honing pattern. NOTE: Minor fading of the honing pattern at the top ring inversion area is not sufficient cause to reject the liner. Figure 1-21 Intact Honing Pattern All information subject to change without notice.

1-32 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION