Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.4 EGR CYLINDER HEAD AND BLOCK 1.4 EGR CYLINDER HEAD AND BLOCK There are several minor changes in the cylinder liner, block and engine lifter brackets between the MBE 4000 EGR engine and the non-EGR engine. 1.4.1 EGR Cylinder Head Installation Be aware of the following notice when installing the cylinder head on an EGR engine: NOTICE: Be sure the carbon scraper ring is seated in the groove on the top part of the cylinder liner before installing a new cylinder head gasket and the cylinder head, otherwise component damage can result. See Figure 1-29. 1. Cylinder Liner 3. Installed Piston 2. Carbon Scraper Ring 4.

Carbon Scraper Ring located in groove in cylinder liner Figure 1-29 Installed Carbon Scraper Ring NOTE: All remaining installation procedures for the cylinder head are identical to a non-EGR engine. All information subject to change without notice. 1-40 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION