MBE 4000 SERVICE MANUAL 1.4.2 Cylinder Head Changes There is also drilling in the head to attach the new EGR cooler support bracket. There is hardening at block division face of cylinder head also. See Figure 1-30. 1. Drilling to attach the EGR Cooler Support Bracket 2. Hardening at Block Division Face Figure 1-30 EGR Cylinder Head Changes 1.4.3 Cylinder Liner Changes One difference between the non-EGR cylinder liner to the EGR model is a groove on the top part of the cylinder liner, which houses the carbon scraper ring. See Figure 1-29. The carbon scraper ring for the EGR engine is in the area previously hardened in the non-EGR cylinder liner. Its purpose is to inhibit coke formation.
All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-41