MACHINE OPERATIONS AND CONTROLS OPERATION CHECK FOR WATER AND SEDIMENT IN WATER SEPARATOR, DRAIN WATER 1. Open the cover at the rear right of the machine. 2. Inspect the water separator, and check if the ring inside has risen to the marked line. 3. If the ring has risen to the marked line, carry out the pro- cedure from Step 4. 4. Set a container under the water separator to catch the drained oil. 5. Close fuel valve (6) at the bottom of the fuel tank. 6. Remove air bleed plug (5) at the top of the water separa- tor. 7. Loosen drain valve (1) at the bottom of the water separa- tor, and drain the water and sediment into the container. 8. Loosen ring nut (2), then remove filter case (3). 9.
Remove element (4) from the separator base. 10. Wash element (4) in clean diesel oil. 11. Check element (4), and replace it if it is damaged. 12. When installing element (4), perform Steps 6 and 7 in the opposite order. Tightening torque of ring nut (2): 40 ± 3 N•m {4.1 ± 0.3kgf•m} 13. Loosen air bleed plug (5) and fill inside of filter case (3) with fuel. When fuel comes out from air bleed plug (5), tighten air bleed plug (5). 3-62