Komatsu — ADJUST BEFORE OPERATION

OPERATION MACHINE OPERATIONS AND CONTROLS ADJUST BEFORE OPERATION WARNING Adjust the seat position before starting operations or after changing the operator. Adjust the seat so that the control levers and switchis can be operated freely and easily with the oper- ator back against the backrest. A: Fore-and-aft adjustment Pull lever (1) up, set the seat to the desired position, then release the lever. Fore-and-aft adjustment: 160 mm (6.3 in) (16 stages) B:

Adjusting reclining NOTICE The seat can be reclined to a large angle when the seat is pushed fully forward, but the reclining angle is reduced when the seat is moved back, so when moving the seat to the rear, return the seat back to its original position. Pull lever (2) and set the seat back to a position which is com- fortable for operation, then release the lever. Sit with your back against the seat back when adjusting. If your back is not touching the seat back, the seat back may suddenly move forward.

C:Adjusting seat tilt Forward tilt Push lever (3) up to adjust the angle of the front of the seat.(4 stages) To raise the angle at the front of the seat, keep the lever pushed up and apply your weight to the rear of the seat. To lower the angle at the front of the seat, keep the lever pushed up and apply your weight to the front of the seat. Rear tilt Pull lever (4) up to adjust the angle of the rear of the seat.(4stages) To raise the angle at the rear of the seat,keep the lever(3) pulled up and stand up slightly to remove your weight from the seat. To lower the angle at the rear of the seat,keep the lever(3) pulled up and apply your weight to the rear of the seat.

Amount of tilt:Up 13°,down 13° Adjusting seat height It is possible to move the seat up or down by combining adjustments 1 and 2. After setting the forward tilt or rear tilt to the desired height, operate the opposite part to set the seat horizontal then secure in position. Height adjustment:60 mm (2.4 in) 3-65