MACHINE OPERATIONS AND CONTROLS OPERATION D:Adjusting armrest angle Armrest (5) can be made to spring up by hand approx.90°. In addition, by turning the bottom (6) of the armrest by hand it is possible to make fine vertical adjustments of the armrest angle. Armrest adjustment angle:25° REMARK If the seat back is tipped to the front without raising the armrest(5), the armrest will rise automatically. E:Overall fore-and-aft adjustment of seat Move lever (7) to right, set to the desired position, then release the lever. In this case, the operator's seat, left and right control levers, and safety lock lever all slide together.
Fore-and-aft adjustment:180 mm (7.1 in) (9 stages) F:Adjusting suspension Turn knob (8) to the right to make the suspension harder,or to the left to make the suspension softer. Adjust the reading of the dial to match the operator's weight and select the optimum suspension. REMARK To obtain the optimum adjustment,turn the knob (8) so that the indicator of the weight display (kg) in the transpar- ent portion of knob (8) is the same as the operator's weight. ADJUSTMENT OF MIRRORS Loosen nut (1) and bolt (2) mounting the mirror, and adjust to the position which gives the best view from the operator's seat of the blind spot to the left and right sides at the rear of the machine.
Adjust the mirror mount so that it is possible to see any person (or object of height 1 m (3 ft 3 in) and diameter 30 cm (11.8 in)) at the rear left and right of the machine. Install the mirror to the mounting position and dimensions shown. The values given below are reference values for the range of view. Mounting position X : 100 mm (3.9 in) Range of view Y (right side) : 1500 mm (4 ft 11in) Range of view Z. (left side) : 1830 mm (6 ft) Mirror A : Must be able to see hatched area (A) Mirror B : Must be able to see hatched area (B) Mirror C : Must be able to see hatched area (C) (if equipped) 3-66