Komatsu — WARMING-UP OPERATION

OPERATION MACHINE OPERATIONS AND CONTROLS WARMING-UP OPERATION NOTICE When the hydraulic oil is at a low temperature, do not carry out operations or move the levers suddenly. Always carry out the warming-up operation. This will help to extend the machine life. Do not suddenly accelerate the engine before the warming-up operation is completed. Do not run the engine at low idling or high idling con- tinuously for more than 20 minutes. This will cause leakage of oil from the turbocharger oil supply piping. If it is necessary to run the engine at idling, apply a load from time to time or run the engine at a mid-range speed.

REMARK If the engine water temperature is above 30єC, to protect the turbocharger, the engine speed does not rise for 2 seconds after starting, even if the fuel control dial is turned. If the hydraulic oil temperature is low, the hydraulic oil temperature monitor display will be white. After starting the engine, do not immediately start operations. First, carry out the following operations and checks. 1. Turn fuel control dial (2) to the center position between LOW IDLING and HIGH IDLING and run the engine at medium speed for about 5 minutes with no load. 2. Set safety lock lever (1) to the FREE position, and raise the bucket from the ground. 3-75