MACHINE OPERATIONS AND CONTROLS OPERATION WORK EQUIPMENT CONTROLS AND OPERATIONS WARNING If the lever is operated when the auto-deceleration is being actuated, the engine speed will suddenly rise, so be careful when operating the lever. If the work equipment control lever is operated quickly, the work equipment will move quickly; if the lever is operated slowly, the work equipment will move slowly. The work equipment is operated by the left and right work equipment control levers. The left work equipment con- trol lever operates the arm and swing, and the right work equipment control lever operates the boom and bucket.
The movements of the lever and work equipment are as shown in the diagrams on the right. When the levers are released, they automatically return to the neutral position and the work equipment is held in place When the machine is at a standstill, and the work equipment levers are put in neutral, the engine speed is kept at medium speed due to the function of the auto-deceleration, even if the fuel control dial is set at the MAX position. REMARK If the levers are operated within 15 seconds after stopping the engine,it is possible to lower the work equipment to the ground.
In addition, the levers can also be operated to release any remaining pressure inside the hydraulic cylinder circuit and to lower the boom after loading the machine on a trailer. Arm control Move the left work equipment control lever to the front or rear to operate the arm. Swing control Move the left work equipment control lever to the left or right to swing the upper structure. 3-88