Komatsu — PRECAUTIONS ON SLOPES

OPERATION MACHINE OPERATIONS AND CONTROLS 2. When traveling up a steep hill of more than 15є, set the work equipment to the posture shown in the diagram on the right. When traveling up steep slopes, to ensure the balance, extend the work equipment to the front, keep it raised 20 - 30cm (10 - 20in) from the ground surface, and travel at low speed. TRAVELING DOWNHILL To brake the machine during downhill runs, put the travel lever in the neutral position. This will cause the brake to be automatically applied. ENGINE STOPPED ON SLOPE If the engine stops when traveling uphill, move the all levers to the neutral position, then start the engine again.

PRECAUTIONS ON SLOPES If the engine stops when the machine is on a slope, never use the left work equipment control lever to carry out swing operations. The upper structure will swing under its own weight. Be extremely careful when opening or closing the door on slopes. The weight of the door may cause the door to open or close suddenly. Always set the door so that it is firmly locked in position. 3-95