MACHINE OPERATIONS AND CONTROLS OPERATION ESCAPE FROM MUD Always operate carefully to avoid getting affixed in mud. If the machine does get affixed in mud, do as follows to get the machine out. STUCK ONE SIDE OF TRACK NOTICE When using the boom or arm to raise the machine, always havethe bottom of the bucket in contact with the ground. (Never pushwith the teeth). The angle between the boom and arm should be 90є to 110є. The same applies when using the inverting bucket. When only one side is stuck in mud, use the bucket to raise the track, then lay boards or logs and drive the machine out. If nec- essary, put a board under the bucket also.
STUCK BOTH SIDES OF TRACKS If the track on both sides are in mud and the machine slips and cannot move, use the procedure given above to lay logs or tim- ber. dig the bucket into the ground at the front, operate the arm in the same way as when digging, and set the travel lever to FORWARD to pull the machine out. 3-96