OPERATION TRANSPORTATION LIFTING MACHINE WARNING Never raise the machine with any worker on it. Always make sure that the wire rope used for lifting the machine is of ample strength for the weight of the machine. Never try to lift the machine in any posture other than the posture given in the procedure below. There is a hazard that the machine may lose its balance. Never lift the machine with the upper structure swung to the side. Swing the work equipment so that it is at the sprocket end and set the undercarriage and upper structure parallel before lifting. When lifting, keep the machine horizontal. It is dangerous to go under the machine when it is raised.
Never go under the machine in such cases. STANDARD SPECIFICATION MACHINE NOTICE The lifting procedure applies to machines with standard specifications. The method of lifting differs according to the attachments and options actually installed. In such cases, please contact your Komatsu distributor for information. For details of the weight, see "SPECIFICATIONS (PAGE 5-2)". When lifting the machine, carry out the operation on flat ground as follows. 1. Swing the upper structure so that the work equipment is at sprocket end. 2. Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown in the diagram on the right using the boom cylinder. 3.
Stop the engine, check that there is nothing around the operator's compartment, then get off the machine. Close the cab door and front glass securely. 3-113