MAINTENANCE MAINTENANCE PROCEDURE WHEN REQUIRED CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT WARNING If inspection, cleaning, or maintenance is carried out with the engine running, dirt will enter the engine and cause damage to the engine. Always stop the engine before carrying out these opera- tions. When using compressed air, there is danger of dirt flying and causing personal injury. Always wear protective glasses, dust mask, or other protective equipment. When removing the outer element from the air cleaner body, it is dangerous to pull it out by force.
When working at high places or where the foothold is poor, be careful not to fall because of the reac- tion when pulling out the outer element. Checking If air cleaner clogging monitor(1) of the monitor panel flashes, clean the air cleaner element. Replacing Replacing element, O-ring If one year has passed since installing the element or if air cleaner clogging monitor (1) on the monitor panel flashes immediately after the element is cleaned, replace the outer element, inner element, and O-ring. Replacing evacuator valve Replace it if it is damaged or the rubber is markedly deformed.
NOTICE Do not clean the air cleaner element until the air cleaner clogging monitor on the monitor panel flashes. If the element is cleaned frequently before the clogging monitor flashes, the air cleaner will not be able to display its performance fully, and the cleaning efficiency will also go down. In addition, during the cleaning operation, more dirt stuck to the element will fall inside the inner element. Outer Element - Clean 1. Open the rear door at the left side of the machine, remove 3 hooks (2), then remove cover (3). NOTICE Before and after cleaning the element, do not leave or keep it in direct sunlight. 2.
Hold the outer element, rock it lightly up and down and to the left and right, and rotate the element to the left and right to pull it out. 4-21