Komatsu — METHOD OF SETTING MACHINE ANGLE

MAINTENANCE PROCEDURE MAINTENANCE METHOD OF SETTING MACHINE ANGLE Method Using Slope WARNING Select a firm flat place. Always put blocks under the track to prevent the machine from moving, and dig the work equipment into the ground. 1. Stop machine so that the work equipment is on the down- hill side. 2. Put blocks under the track and dig the work equipment into the ground. Method Using Block WARNING Select a firm flat place. Put strong blocks under the undercarriage to stabilize the machine and be extremely careful when carry- ing out the operation. 1. Raise the chassis with the boom and arm. When doing this, operate the levers slowly. 2.

Insert a block securely between the ground surface and the raised track and make sure that the machine is sta- ble. 3. Raise the boom slowly and lower the machine. When doing this, check that the machine is always sta- ble. 4-42