MAINTENANCE MAINTENANCE PROCEDURE BLEEDING AIR FROM HYDRAULIC SYSTEM For details, see "STARTING ENGINE (PAGE 3-70)". If it is necessary to refer to the items for starting the engine, moving the machine off, steering, or stopping, see the OPERATION section. 1. Bleeding air from pump 1) Loosen air bleed plug (1) and check if oil oozes out. 2) If the oil does not ooze out, remove the drain hose from the hydraulic pump case and fill the pump case completely with hydraulic oil through drain port (2). Hold the removed hose firmly, keeping the mouth- piece higher than the oil level in the hydraulic tank so that oil will not spill out of the hose.
3) After air bleeding is completed, first tighten air bleed plug (1) and then install the drain hose. NOTICE If the drain hose is installed first, oil will spurt out of air bleed plug (1). If the pump is run when the pump case is not full of oil, there will be abnormal generation of heat, and this will lead to premature failure of the pump. 2. Starting engine Start the engine. For details, see "STARTING ENGINE (PAGE 3-70)". Run the engine at low idling for 10 minutes after starting, then start operations. 3. Bleeding air from cylinders 1) Run the engine at a low idling and extend and retract the cylinders 4 to 5 times to a point 100 mm(3.9in) from the end of the stroke.
(Be careful not to operate to the end of the stroke.) 2) Next, operate each cylinder 3 to 4 times to the end of its stroke. 3) Finally, operate each cylinder 4 to 5 times to the end of its stroke to completely remove the air. NOTICE If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing. 4. Bleeding air from swing motor 1) Run the engine at low idling, loosen hose (1) at port S, and check that oil oozes out from port S hose (1). NOTICE Do not operate the swing under any circumstances.
2) If oil does not ooze out, stop the engine, remove port S hose (1), and fill the inside of the motor case with hydraulic oil. 3) After completely bleeding the air, tighten port S hose (1). 4) Run the engine at low idling and slowly swing at least two times uniformly to the left and right. This will automatically bleed the air. NOTICE If the air is not bled from the swing motor, there is danger that the motor bearings will be damaged. If the swing motor safety valve is to be replaced, ask your Komatsu distributor to carry out the replacement and air bleed operation. 4-43