MAINTENANCE MAINTENANCE PROCEDURE CHECK, ADJUST TENSION OF AIR CONDITIONER COMPRESSOR BELT Checking Press the belt at a point midway between the drive pulley and compressor pulley with a finger force of approx. 58.8 N (6 kgf) and check that the deflection is 5 - 8 mm (0.20 in - 0.31 in). Adjusting 1. Loosen bolts (1) and (2). Bracket (4) holds the compressor in place. When bolts (1) and (2) are loosened, bracket (4) moves with the securing position of bolt (2) as a fulcrum. 2. Loosen nut (5) attached to the fixed bracket (3) and then tighten bolt (6). Tighten bolt (6) so that the deflection of the belt will be 5 - 8 mm (approx. 58.8N (6 kgf)). 3.
Tighten bolts (1) and (2) to secure bracket (4). 4. Loosen bolt (6) to remove from bracket (4). 5. Tighten nut (5). 6. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 7. Replace belt if it has stretched, leaving no allowance for adjustment, or if there is a cut or crack on V-belt. 8. When the new V-belt is set, readjust it after operation for an hour. 4-53