Komatsu — CHECK SWING PINION GREASE LEVEL, ADD GREASE

MAINTENANCE PROCEDURE MAINTENANCE REPLACE ADDITIONAL FUEL FILTER G The engine is at high temperature after machine operation. wait for the engine to cool down before replacing filter. G Do not bring any fire or flame close to the fuel. Prepare a filter wrench and an oil container. 1. Place the container under filter to receive oil. 2. Rotate filter (2) counter-clockwise with filter wrench to remove the filter . 3. Clean the filter head, and use clean fuel to clean new fil- ter, and apply engine oil to the matching surface. Then, install it to filter head. 4. Tighten to make the sealing surface contact the sealing surface of filter head while installing, then tighten another 1/2 turn.

If the filter is excessively tightened, the matching surface will be damaged, causing oil leak If the filter is to loose, fuel will leak from the matching sur- face, so tigheten it properly. 5. Bleeding air after additional fuel filter is replaced. RCHECK SWING PINION GREASE LEVEL, ADD GREASE Prepare a scale. 1. Remove bolts (1) (2 bolts) on the top of the revolving frame and remove cover (2). 2. Insert a scale into the grease and check that the height of the grease in the portion where the pinion passes is at least 14 mm (0.6 in). Add more grease if necessary. 3. Check if the grease is milky white. If it is milky white, it is necessary to change the grease.

Please contact your Komatsu distributor. The total amount of grease PC200,PC210 : 14.6 liters (3.86 US gal) PC220 : 15.8 liters (4.17 US gal) 4. Install cover (2) with bolts (1). 4-57 WARNING