Komatsu — CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS AND CONDENSER FINS

MAINTENANCE PROCEDURE MAINTENANCE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS AND CONDENSER FINS WARNING If compressed air, high-pressure water, or steamhit your body directly, or they cause dirt or dust to be blown up, there is a hazard of serious injury. Always use safety glasses, dust mask, or other protective equipment. NOTICE When using compressed air, if the nozzle is brought too near the fins, the fins may be damaged. Carry out the cleaning from a reasonable distance to prevent damage to the fins. Do not direct the jet directly at the core. If the fins are damaged, it will cause leakage of water and over- heating.

On dusty jobsites, carry out this inspection every day, regardless of the maintenance interval. 1. Open engine hood (1). 2. Loosen screw (3) and pull up net (2). 3. Clean net (2). (it is to be installed again, as instructed in the item 8) 4. Loosen screw (5) and detach net (6) between the radiator and the oil cooler. 5. Inspect the front and rear of oil cooler fins (4), radiator fins (7), after-cooler fins (8) and condenser fins (9) for dirt, dust, dry leaves, etc. Blow them away with com- pressed air, if any. Steam or water may be used instead of compressed air. 6. Check the rubber hose. Replace with a new one, if the hose is found to have cracks or to be hardened by aging.

Further, check the hose cramps for looseness. 7. Remove cover (10) of the under cover and dispose of the dirt, dust, dry leaves, etc. fallen on it. 8. Push in cleaned net (2) back to the original place and secure it with screw (3). 9. Secure net (6) with screw (5). 4-58