Komatsu — CHANGE OIL IN SWING MACHINERY CASE

MAINTENANCE PROCEDURE MAINTENANCE CHANGE OIL IN SWING MACHINERY CASE WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. Refill capacity: 6.6 liters (1.74 US gal) 1. Remove cover (A) of the inspection hole. 2. Set an oil container under drain valve (P) under the machine body. 3. Loosen drain valve (P) under the body, drain the oil, then tighten the drain valve again. 4. Remove the cap of oil filler (F), then add the specified amount of engine oil through oil filler (F). 5. Pull out dipstick (G) and wipe off oil on the dipstick with cloth. 6.

Insert dipstick (G) into the gauge pipe thoroughly and then pull out it again. 7. When the oil level is between the H and L marks, on dip- stick (G), it is normal. If the oil does not reach the L mark, add more oil through oil filler (F). 8. If the oil level exceeds the H mark, drain the excess engine oil from drain valve (P), and check the oil level again. When draining the excess engine oil, pull out hose (1) from the check hole and then open the drain valve. 4-64