Komatsu — CHANGE OIL IN FINAL DRIVE CASE

MAINTENANCE PROCEDURE MAINTENANCE EVERY 2000 HOURS MAINTENANCE Maintenance for every 100, 250, 500 and 1000 hours service should be carried out at the same time. CHANGE OIL IN FINAL DRIVE CASE WARNING The oil is at high temperature after the engine is stopped. Wait for the temperature to go down before starting the operation. If there is pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Refill capacity (each): 4.5 liters (1.19 US gal) Hexagon wrench 1. Set the final drive the way TOP mark comes to the top and the mark and plug (P) are perpendicular to the ground. 2. Set a container under plug (P) to catch the oil. 3.

Remove plugs (P) and (F) with the hexagon wrench and drain the oil. REMARK Check the O-rings in the plugs for damage. If necessary, replace with new ones. 4. Tighten plug (P). 5. Add engine oil trough the hole of plug (F). 6. When the oil overflows from the hole of plug (F), install plug (F). Plugs (P) and (F) are tightened to the torque of 68.6±9.8N•m (7±1 kgf•m). REMARK There are two plugs (F). Add oil through the one easier to fill oil and through which no internal gears are to be seen. 4-66