ATTACHMENTS AND OPTIONS MACHINES READY FOR ATTACHMENTS SELECTOR VALVE This valve (2) switches the flow of hydraulic oil. It is automatically switched according to the selected working mode. It is necessary to switch the working mode to match the attachment that is installed. For details of switching the work- ing mode, see "HYDRAULIC CIRCUIT (PAGE 6-9)". NOTICE If a service circuit from the attachment maker has been added, the return circuit may not switch automatically. ATTACHMENT CONTROL PEDAL This pedal (3) is used to control the attachment. When the front, center (neutral), and rear of the pedal are depressed, the movement of the attachment is as follows.
Hydraulic breaker Front of pedal (A) : Actuated Center of pedal N : Stopped Rear of pedal (B) : Stopped Regarding other attachments, hold a meeting with the attach- ment maker at the time of installation to confirm the operation of the pedal and attachment before using it. REMARK This pedal cover (3) differs in thickness at both ends. It can be stalled facing in either direction, so install it accord- ing to your own preference. LOCK PIN This pin (4) locks the control pedal. Position (a) : Locked Position (b) : Only front of pedal can be operated to full posi- tion (rear is locked) Position (c) :
Both front and rear of pedal can be operated to full position When using a breaker, select B mode on the monitor and set the lock pin to position (b). When not using the attachment, set the lock pin to position (a). When using a breaker, select A or E mode on the monitor and set the lock pin to position (c). NOTICE When using a breaker, if the lock pin is set to position (c) and the rear portion (B) of the pedal is depressed, it will cause defective operation or breakage of the breaker, so always set the lock pin to posi- tion (b) when using the breaker. 6-7