ATTACHMENTS AND OPTIONS ATTACHMENT GUIDE SELECTION OF TRACK SHOES Select suitable track shoes to match the operating conditions. METHOD OF SELECTING SHOES Confirm the category from the list of uses in Table 1,then use Table 2 to select the shoe. Categories B and C are wide shoes, so there are limitations on their use.When using these shoes,check the pre- cautions, then investigate and study fully the conditions of use to confirm that these shoses are suitable. When selecting the shoe width, select the narrowest shoe possible that will give the required flotation and ground pressure.
If a wider shoe than necessary is used, the load on the track will increase,and this will cause the shoes to bend, links to crack, pins to break, shoe bolts to come loose, and various other problems. Table 1 Table 2 6-23 Category Use Precautions when using A Rocky ground, riverbeds, normal soil ● On rough ground with large obstacles such as boulders or fallen trees, travel at low speed. B Normal soil, soft ground ● These shoes cannot be used on rough ground where there are large obstacles such as boulders or fallen trees. ● Travel at Hi or Mi speed only on flat ground, and if it is impossible to avoid going over obstacles, shift down and travel at half speed in Lo.
C Extremely soft ground (swampy ground) ● Use the shoes only in places where the machine sinks and it is impossible to use A or B shoes. ● These shoes cannot be used on rough ground where there are large obstacles such as boulders or fallen trees. ● Travel at Hi or Mi speed only on flat ground, and if it is impossible to avoid going over obstacles, shift down and travel at half speed in Lo. D Paved road ● Take note of low gradeability due to the flat shoes and exercise a due care. E Paved road ● Be sure to follow the instructions set forth in the "Handling of Road Liner" section for the protection of the rubber pad shoes.
PC200, 220-7 PC200LC, 220LC-7 Specifications Category Specifications Category Standard 600mm Triple A 700mm Triple B Option 600mm Road Liner (Rubber pat type) E 600mm Road Liner (Rubber pat type) E Option 610mm Flat D 610mm Flat D Option 700mm Triple B 600mm Triple A Option 800mm Triple C 800mm Triple C Option 860mm Swamp C 860mm Swamp C